CROWN POWER AMP MACRO-TECH 3600VZ Missing Power connector 30 amp 150 Volt - $690 - (Las Vegas, NV)
Crown Macro-Tech 3600vz Please note that the NEMA TT30P plug has been removed and is not included..You MUST HAVE A 30 AMP 120 Volt Receptacle for this amplifier and you need to install a connector These units were removed from a working environment Specifications Note: Specifications relate to 120 volt, 60 Hz units in Stereo mode with 8-ohm loads and an input sensitivity of 26 dB gain at 1 kHz rated power unless otherwise specified. . Power Output Power: See power charts below. Load Impedance: Safe with all types of loads, even reactive ones. MA-3600VZ is rated for 2 to16 ohms in Stereo. amplifiers are rated for 4 to 16 ohms in Bridge-Mono and 1 to 4 ohms in Parallel-Mono mode. Voltage Gain to 8 ohm load at rated output at 1 kHz, maximum level setting: MA-3600VZ: 124.6:1 ±6% or 41.9 dB ±0.5 dB at 0.775 volt sensitivity. 69.2:1 ± 6% or 36.8 dB ±0.5 dB at 1.4 volt sensitivity. 20:1 ±6% or 26 dB ±0.5 dB at +26 dB sensitivity. Required AC Mains (MA-3600VZ): 50/60 Hz; 120VAC (±10%) units are available. 120VAC units can draw up to 30 amps; Current, voltage and frequency requirements are provided on unit’s back panel. AC Line Connector: THIS HAS BEEN REMOVED you need a 3 wire 150 volt 30 amp connector model # 2611 THIS HAS BEEN REMOVED under $20.00 Performance Frequency Response: ±0.1 dB from 20 Hz to 20 kHz at 1 watt. Phase Response: ±10 degrees from 10 Hz to 20 kHz at 1 watt. Signal-to-Noise Ratio: > 105 dB A-weighted or 100 dB unweighted below rated power, 20 Hz - 20 kHz. Total Harmonic Distortion (THD): MA-3600VZ: At full bandwidth power, 1,000 from 10 Hz to 400 Hz. Slew Rate: (Slew rates are limited to useful levels for ultrasonic/RF protection.) > 30 volts per microsecond MA-3600VZ *1KHz power 2 ohm Dual (per ch.) 1800W 4 ohm Dual (per ch.) 1565W 8 ohm Dual (per ch.) 1120W 4 ohm Bridge-Mono 3505W 8 ohm Bridge-Mono 3140W
ADVERTISEMENT
From ebay.com - 1 month ago